Cleaning - Henny Penny BCC/BCR-140 Service Manual

Henny Penny

3-5. CLEANING

300
Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350
Daily:
1. Remove all electrical power supplied to the unit by turning off
the wall circuit breaker.
2. Remove all product from the unit.
3. Remove the racks and pans from the unit and clean with
soap and water at a sink.
4. Clean all surfaces with a soft cloth, soap and water. DO
NOT USE ABRASIVE CLEANSERS.
DO NOT use abrasives, such a steel wool, or abrasive
cleaners, such as, chlorine, bromine, iodine, or ammonia
chemicals to clean the unit. These will deteriorate the
stainless steel and greatly reduce the life of the unit.
5. Clean around the electronic controls and the door seal with
a soft, damp cloth.
DO NOT use large quantities of water, or a spray hose to
clean the unit. Damage to the components could result.
6. Reconnect the electrical power to the unit and unit is now
ready for operation.
Monthly: BCC-140 Only
At least once a month the air condenser needs to be cleaned of
dust or obstructions for the unit to run effeciently and to reduce
energy use of the unit.
1. Remove all electrical power supplied to the unit by unplug-
ging the power cord from the wall, or by turning off the
wall circuit breaker.
2. Using a flathead screwdriver, remove the screws from the
front panel of the unit. Pull panel down and press in on the
side of the panel to release the tabs, and remove the panel
from the unit.
3-8