1-1. INTRODUCTION 1-2. SAFETY 1-3. TROUBLESHOOTING Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 SECTION 1. TROUBLESHOOTING This section provides troubleshooting information in the form of an easy-to-read table. If a problem occurs during the first operation of a cabinet, recheck the installation per the Installation Section of the Operator’s Manual.
Page 6
1-3. TROUBLESHOOTING (Continued) Problem The evaporator is iced-up after a De-icing Cycle Too much water on evaporator fins Slow to decrease in temperature (decline in performance) Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 Cause Faulty de-icing heater Evaporator temperature at end of De-icing Cycle too low Maximum time of De-icing Cycle too short The unit has been shut down without...
Page 7
1-3. TROUBLESHOOTING (Continued) Problem Slow to decrease in temperature (decline in performance) Display temperature does not match the actual inlet air temperature (No alarm) Green compressor indicator light on and the compressor not working, or working sometimes Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 Cause Condenser obstructed by dirt Evaporator iced up...
Page 8
1-3. TROUBLESHOOTING (Continued) Problem Green compressor indicator light off and compressor is working Green fan indicator light on and fan(s) not working All indicator lights off and ON/OFF switch will not operate Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 Cause Voltage across terminals 10-11 of control board: - Control board relay bad No voltage across terminals 10-11...
1-4. ALARM MESSAGES Display Cause “AL-1” Faulty air temperature probe “AL-2” Faulty evaporator probe “AL-3” Faulty Frigiprobe “AL-5” Temperature too low in the hold mode “AL-6” Temperature too high in the hold mode Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 In the event of a system failure, the digital display will show an alarm message.
Page 10
Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350...
Wiring diagrams applicable to the blast chillers and blast freezers are provided on the following pages. Also, two pages are provided after the wiring diagrams which list the service replacement parts available for the various models of the Henny Penny blast chillers and blast freezers.
Page 12
Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350...
Page 13
Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350...
Page 14
Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 2-10...
Page 15
Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 2-11...
Page 16
Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 2-12...
Page 17
During this time, any frypot that fails due to manufacturing or workmanship issues will be replaced at no charge for parts, labor, or freight. Henny Penny will either install a new frypot at no cost or provide a new or reconditioned replacement fryer at no cost.
This section identifies and lists the replaceable parts of the Henny Penny blast chiller/freezer. Use only genuine Henny Penny parts in your cabinet. Using a part of lesser quality or substitute design may result in cabinet damage or personal injury.
Page 19
Item Part No. √ √ √ √ √ 1 9504.0205 Control PC Board √ √ √ √ √ 2 9503.3692 Display PC Board √ √ √ √ √ 3 9503.3700 Auxiliary Display Board 9503.3759 Connecting Cable √ √ √ √ √ 5 9503.7719 Communication Board 9503.8436...
Page 20
Item Part 9500.8967 Nozzle-Expansion Valve BFR-350 9500.7993 Water Pressure Valve - BCC-175 √ √ √ √ √ 33 9503.6182 High Pressure Switch - BCC-140 9502.5045 Liquid Receiver - BCC-140 9550.4585 Door - BCC/BCR-175/350 9550.6630 Door - BCC/BCR-140 9543.0831 Front Panel for Printer - BCC/BCR-175 9542.5989 Front Panel for Printer - BCC/BCR-140 9541.6053...