Start-Up - Henny Penny HUMIDIFIED COUNTER WARMER HCS-2 Operator's Manual

3-2. OPERATING CONTROLS (Continued)
Fig. Item
No. No.
3-11 22 Float Switch
3-12 23

3-3. START-UP

3-6
Description
Water Heater
Before using, the Henny Penny Heated Display Cabinet
should be thoroughly cleaned as indicated in the Shut-Down
and Cleanup section of this manual.
1. Move all switches and controls on the cabinet to the OFF
2. Turn on power supply for the cabinet at the main circuit
Step 2
3. Place the grids in the water pan.
Step 3
An electro-mechanical sensing device used to automati-
cally control the water level in the water pan; the float
switch can be inactivated by the water control switch;
the float switch illuminates the low water light when it
senses a low water condition
Two flat strip heaters, attached to the bottom of the
water pan, which measure approximately 3" wide by
25" long, and are rated at 1020 watts each
position.
breaker.
Model HCS-2/HCW-3/HCW-5/HCW-8
Function
1105