Table of Contents
Advertisement
2-6. STACKING AND OUTBOARD
CASTER INSTALLATION
INSTRUCTIONS
Figure 1
Figure 2
Figure 3
105
1. Using a Phillip's head screwdriver, remove the 8, 1/4-20 x
1 in. screws in the corners of the unit. Figure 1.
2. Remove all contents from inside of unit. Carefully lay the
unit over onto the customer side of the unit. Be sure to
protect the glass door from damage, such as placing pack-
ing material between unit and a wood pallet. (If the door
on the customer side has a handle on it, allow the door
handle to hang over the edge to the wood pallet.)
3. Using a 7/16 in. wrench or socket, remove the bolts, wash-
ers and lockwashers from the bottom of the unit.
4.
Using the hardware removed in step 3, and the caster
mounting holes in the bottom of the unit, fasten the out-
board caster brackets to the bottom of the unit, along
with the stacking spacer, if present. (The stacking spacer
should be on the customer side of the unit.) Then, using 8,
1/4-20 x 1 in. screws (from step 1) fasten the caster brack-
ets to both sides of the unit. Figures 2 & 3.
The brackets can be used on either side, thus the 16
mounting holes in the bracket, shown in Figure 2.
SCR-6/8
2-5
Hide quick links:
Advertisement
Table of Contents
