Log Set Installation Instructions; Installation - Lennox Hearth Products Winslow PI40 Installation And Operation Manual

Log Set Installation Instructions

(ref. form # 775275M)
Kit Contents
(refer to Figure 30)
1 ea. Left Log (A)
1 ea. Right Log (B)
1 ea. Front Log (C)
2 ea. Log Support Brackets (D)
1 ea. Instruction Sheet
Cat. No.
H 5142 P40LOG
A
Figure 30 - Kit contents
Tools Required
None
CAUTION: The logs can be damaged if they are not handled
with care!
To Install the log set:
1. Remove the two log support brackets (D) from the box and bend the
ends of the brackets 90 degrees at the bend lines. See Figures 31 and
32.
2. One bracket goes into the left corner and the other into the right corner
of the firebox. Rotate the brackets (D) so they are placed as shown
in Figure 32. The bracket fits between the back of the firebox and the
air wash at the front of the insert.
3. Remove the ceramic logs from the box and carefully unwrap them.
Position each back log (A and B in Figure 33) in their proper place,
one on each side against the back of the firebox.
4. The front log should face the front of the firebox with the wood grain
showing. It should rest on the other two back logs. See Figure 33
for assembled log set.
18
Model Description
Winslow Log Set
B
C
D
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
bend lines
Figure 31 - Log Support Brackets
Bracket correctly placed
D
Figure 32 - Log Support Bracket
A
Figure 33 - Completed Installation
D
B
C