Log Set Installation Instructions - Lennox Hearth Products Winslow PI40 Installation And Operation Manual

Log Set Installation Instructions

Kit Contents
(refer to Figure 30)
Cat. No. #H514
Qty
(1) left log (B)
(1) right log (C)
(1) front log (D)
(2) log support brackets (E)
B
Figure 30
Tools Required
None
CAUTION: The logs can be damaged if they are not handled
with care!
To Install the log set:
1. Remove the two log support brackets from the box and bend the ends
of the brackets 90 degrees at the cut lines. See Figure 31.
2. One bracket goes into the left corner and the other into the right corner
of the firebox. Rotate the brackets so they are placed as shown in
Figure 32. The bracket fits between the back of the firebox and the
air wash at the front of the insert.
3. Remove the ceramic logs from the box and carefully unwrap them.
Position each back log (Figure 33, B, C) in their proper place, one
on each side against the back of the firebox.
4. The front log should face the front of the firebox with the wood grain
showing. It should rest on the other two back logs. See Figure 33
for assembled log set.
C
D
E
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 31
E
Figure 32
B
Figure 33
cut lines
Bracket correctly placed
C
D
17