Editing Program - American DJ Accu Spot 250 User Instructions

Accu Spot 250™
STEP
- With this function you can define the number of
steps in the Run Program.
1. Access the main menu.
2. Tap the UP button until "EDIT" is displayed, press ENTER.
3. Tap the UP button until "STEP" is displayed, press ENTER.
4. The display shows "S-XX", "X" stands for the total amount
of steps you want to save, so you can call up to 48 scenes in
"Run". For example, if the "XX" is 05, it means that "Run" will
run the first 5 scenes you saved in "Edit".
5. Press ENTER to save and exit.
EDIT
- This menu item allows you to write a program into the
memory (EEPROM) via the control panel or via the external
controller.
Editing procedure 1: Using the control board only.
1. Access the main menu.
2. Tap the UP button until "EDIT" is displayed. Press ENTER.
3. The display will show "SCXX", the "X" again stands for the
scene number. For example, "SC01" is displayed, it means you
will be editing scene 1, press ENTER. You can change the
scene number by pressing the UP button.
4. Press ENTER, the display will show "C-X", the "X" again
stands for the channel number. If "C-01" is displayed, you will
be editing channel 1 of your selected scene, press ENTER. You
can change the scene number by pressing the UP button.
5. The display will show the DMX value for the channel that is
being edited. It will be displayed as "11XX", it stands for Channel
11 of the editing scene, the DMX value is "XX".
American DJ - www.americandj.com - Accu Spot 250™ Instruction Manual Page 25
®

Editing Program

Accu Spot 250™
6. Adjust the DMX value by pressing the UP button, until you
get the expected effect for this channel.
7. Press ENTER to enter the editing of the other channels of the
scene.
8. Repeat steps 5-8, until you finish setting all the DMX values
for all the channels of this scene, each scene can have 15
channels maximum.
9. Once all the channels are completed, the display will flash
"TIME", this stands for the time needed to run this scene.
10. Press ENTER to edit the time needed, the display shows
"T--X", "X" stands for the time needed to run this scene. For
example, "T--2" means scene 1 needs 2 seconds to run, "T-15"
means scene 1 needs 15 seconds to run.
11. Adjust the time needed by pressing the UP button.
12. Press ENTER to save the settings for the scene you are
editing, the display will change to the next scene automatically.
13. Repeat steps 3-12 to edit other scenes, you can edit and
save 48 scenes maximum.
14. Press EXIT/DN to exit, now you have edited and saved
scenes using the control board. The number of steps can be
defined under "Step" and the scenes can be called up under
"Run". To run the scenes see page 18.
American DJ - www.americandj.com - Accu Spot 250™ Instruction Manual Page 26
®
Editing Program