American DJ Accu Spot 250 User Instructions page 8

Accu Spot 250™
RTILT (Reverse Tilt) - Reverses the tilt.
LODA - Restores factory settings.
VER (Version) - Software version 2.2
ADJUST MENU -
LADJ (Lamp Adjustment) - With this function you can adjust
the lamp via the control board. In this mode, the device will not
react to any control signal.
TEST (Test) - Tests the functions of each channel. There are eight
channels, but only channels 1,2,3,4, and 6 can be tested.
TIME MENU -
CLLT - Clears the lamp running time.
NAT 1 - Displays the fixture running time.
LAT 1 - Displays the lamp running time.
CLNT - Clears the fixture running time.
EDIT MENU -
STEP (Step) - Steps to be used in Edit Programming. See ediit
program. See page 27.
SCO1 - SC48 (Scene 01 - Scene 48) - These are the scene slots
that you write your programs into. See edit program, page 28.
TIME (Time) - Time for each scene. See page 28.
CNIN - Edit program using a external controller. See page 30.
C-01 - C-30 (Channel 1 - Channel 30) - The channels of each
scene that can be edited. See page 28.
American DJ - www.americandj.com - Accu Spot 250™ Instruction Manual Page 15
®
System Menu Accu Spot 250™
On-Board System Menu.
easy to navigate system menu. This next section will detail the func-
tions of each command in the system menu.
Enter Button -
(3) on the side of the unit. Press this button for 3 seconds to activate
the system menu. Tap the UP button (5) until you reach function you
wish to change. When you reach the function you wish to change tap
the ENTER button. When a function is selected the menu will begin to
flash, use the UP button to change the function. Once your changes
are made tap the ENTER button again to lock the change in the system,
if the ENTER button is not selected within eight seconds the system
will automatically return to menu section. To exit without making any
changes tap the EXIT/DN button (4).
MODE MAIN MENU -
ADDR
1. Access the main menu.
2. Tap the UP button until "NODE" is displayed, press ENTER.
3. Tap the UP button until "ADDR" will now be displayed. Press
ENTER.
4. Now the display will show "VALU", press ENTER. Now, "A001"
should be displayed. Adjust the DMX address by pressing the
UP or DOWN buttons.
5. Press ENTER to confirm.
6. Press the EXIT/DN button to return to the main menu.
When the display is on "A001", you can directly press the UP
or DN buttons to change the DMX start address.
SLAV
1. Access the main menu.
American DJ
The Accu Spot 250™ comes with an
To access the main menu locate the ENTER button
DMX Address Setting via control board -
Define the unit as a slave, in master/slave mode -
- www.americandj.com - Accu Spot 250™ Instruction Manual Page 16
®
System Menu