Fuse And Lamp Replacement - American DJ Accu Spot 250 User Instructions

Accu Spot 250™
Stand-Alone Operation (Sound Active):
single unit or several units linked together, to run to the beat of the
music.
1. Access the main menu.
"NODE" is displayed, and Press ENTER.
2. Tap the UP button until
3.
Tap the UP button until "RUN" is displayed, and Press ENTER.
4. "AUTO" is displayed. If you press the UP button it will show
"SOUN". Select which one you want to activate, and press ENTER.
5. Press UP, to select "ALON" or "NAST". Which mean stand alone,
or master/slave mode.
6. Select a mode, and press ENTER to confirm.
7. Press EXIT/DN to return to the main menu
8. The unit comes with two preprogrammed shows built-in, each
show will react to low frequencies via the internal microphone.
You may change the show or invert the pan and tilt functions by
in the system menu by following the directions on page 21.
Master-Slave Operation (Sound Active):
you to link up to 16 units together and operate without a controller. The
units will be sound activated. In Master-Slave operation one unit will
act as the controlling unit and the others will react to the controlling
units programs. Any unit can act as a Master or as a Slave.
1. Using standard XLR microphone cables, daisy chain your units
together via the XLR connector on the rear of the units. Remem-
ber the Male XLR connector is the input and the Female XLR
connector is the output. The first unit in the chain (master) will use
the female XLR connector only - The last unit in the chain will use
the male XLR connector only. For longer cable runs we suggest a
terminator at the last fixture.
2. Follow the procedures on page 16 under "SLAV", and page 18
under "RUN" to set the master and slave units.
American DJ - www.americandj.com - Accu Spot 250™ Instruction Manual Page 29
®
Operation
This mode allows a
This function will allow
Accu Spot 250™
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
technician. Replacing with anything other than the specified part can
damage your unit and will void your manufactures warranty.
Warning:
If you continue to blow lamps or fuses, STOP using the
unit. Contact customer support for further instructions, you may have
to return the unit for servicing. Continuing to use the unit may cause
serious damage.
Lamp Replacement:
Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace the
lamp. Lamp replacement has been made simple by incorporating the
use of a flip-up front cover that is retained by thumb screws.
1. Be sure to follow the proper handling procedures that deal with
discharge lamps.
2. Remove the two small screws (A,B) on the rear of the unit
3. After removing the screws, gently slide out the socket assembly
from the rear of the unit to expose the lamp.
4. Carefully remove the old lamp and discard it in the trash.
5. Replace the lamp with an exact match and reassemble in reverse
order.
6. After replacing the lamp follow the optimization procedures on the
next page to be sure the lamp is center in the reflector
A
American DJ - www.americandj.com - Accu Spot 250™ Instruction Manual Page 30
®
Fuse & Lamp Replacement
service
®
B