Program Chase - American DJ LED Touch User Instructions

LED Touch™
5-Pin XLR DMX Connectors.
512 data cables for DATA transmission in place of 3-pin. 5-pin DMX
fixtures may be implemented in a 3-pin DMX line. When inserting stan-
dard 5-pin data cables in to a 3-pin line a cable adaptor must be used,
these adaptors are readily available at most electric stores. The chart
below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor 3-Pin XLR Female (Out)
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
American DJ® www.americandj.com - LED Touch
DMX Set Up
Some manufactures use 5-pin DMX-
5-Pin XLR Male (In)
Pin 1 Pin 1
Pin 2 Pin 2
Pin 3 Pin 3
Pin 4 - Do Not Use
Pin 5 - Do Not Use
Page 7
LED Touch™
PROGRAM A CHASE:
You can save 24 chases max, and each chase can include up to 30
scenes.
NOTE: CHASES 1-6 ARE BUILT-IN CHASES THAT YOU SHOULD
NOT EDIT OR DELETE.
1. Enter Program Mode. Hold the PROGRAM/REC button (11) for 3
seconds, the PROGRAM/REC LED will start blinking, indicating
that Program mode is active.
2. Press the CHASE button, and then press either the UP or DOWN
buttons or turn the JOG WHEEL, to select the chase number.
3. Press the SCENE button, and then press either the UP or DOWN
buttons or turn the JOG WHEEL to select the scene number.
4. Press the DIMMER button, the LCD will display "CXX SNXX/"
DIM XXX", press either then UP or DOWN buttons or turn the
JOG WHEEL, to adjust the dimmer.
Note: You should set the dimmer to open or full on (default) or there
will be no LED output.
5. Select your desired fixtures, 1-6, that you would like to operate.
6. Select your desired effect, by pressing either COLOR, FADE, or
MACRO.
COLOR - Choose built-in color by using the UP or DOWN buttons
or turning the jog wheel.
FADE - Use the jog wheel to adjust the fade speed (0s-90m).
MACRO - Select one of 24 macros, and adjust the fade time or
hold time. Press MENU/FADE TIME to adjust the fade time, or press
ENTER/HOLD TIME to set the hold time.
7. Once you have chose your desired effect press the DIMMER but-
ton to select your desired intensity.
8. Press the PROGRAM/REC button to store the scene. If the
Program/Rec and Blackout LEDs blink 3 times, the save was suc-
cessfull. The display will show "CXX SXX/STORE OK", and auto-
matically go to the next scene to be set.
American DJ® www.americandj.com - LED Touch
Program A Chase
Page 8