Section 2. Cleaner Specifi Cations; General Specifi Cations; Section 3. Assembly And Initial Usage; Unpacking - Polaris 9300 Sport Owner's Manual

Section 2. Cleaner Specifi cations
2.1 General Specifications
The general specifi cations for the cleaner are as follows:
9300 Sport &
9400 Sport
100-125 VAC, 60 Hz
Control box
supply voltage
30 V DC
Supply voltage
150 W max
Installed load
60 ft (21 m)
Cable length
16.9 x 18.9 x 10.6 in.
Cleaner size
43 x 48 x 27 cm
(WxDxH)
22.8 x 22.8 x 23.2 in.
Pack size
58 x 58 x 59 cm
(WxDxH)
Weight of Cleaner 25 lbs. (11.3 kg)
42 lbs. (19 kg)
Packed weight
less than 100
Filtration
microns
1.30 hrs, 2.30 hrs.
Cycle lengths
The cleaner is a double-insulated product. A double-
insulated electrical appliance is one which has been
designed in such a way that it does not require a safety
connection to ground. The basic requirement for double-
insulation is that no single failure can result in danger-
ous voltage becoming exposed so that it might cause an
electric shock and that this is achieved without relying
on an earthed (grounded) metal casing. This is achieved
by having two (2) layers of insulating material sur-
rounding live parts or by using reinforced insulation.
Therefore, devices having double-insulated construc-
tion, such as this cleaner, do not utilize a grounded
(three-prong) cord/plug.
Section 3. Assembly and Initial
Usage

3.1 Unpacking

The packaging should contain the following items
(Refer to Figure 1):
• Polaris cleaner
• Control unit
• Remote control (9300xi Sport only)
• Transport and storage caddy (complete with
assembly components)
9300xi Sport
100-125 VAC, 60 Hz
30 V DC
150 W max
70 ft (21 m)
Figure 1.
16.9 x 18.9 x 10.6 in.
43 x 48 x 27 cm
Check that the unit has not been damaged during
transport. If you detect damage, contact Zodiac Pool
22.8 x 22.8 x 23.2 in.
Systems, Inc. at 1-800-822-7933 before using your
58 x 58 x 59 cm
cleaner.
25 lbs. (11.3 kg)
To unpack the cleaner and its components:
42 lbs. (19 kg)
1.
less than 100
microns
1.30 hrs, 2.30 hrs.
2
3.
4.

3.2 Assembling the Transport Caddy

1.
Figure 2.
Components
Remove the lower portion of the caddy along with
the upper and lower power cable hooks, control
unit hook, power cable hook plate, locking plate,
nuts, bolts and screws.
Remove the small box that contains the control unit.
Remove the handles (left and right) of the caddy,
which are located against one side of the box.
Remove the cleaner from the box.
Insert the upper tubes (handles) into the bottom
tubes on the cart as shown in Figure 2. Make
sure the upper tubes (handles) are in the proper
orientation and align the screw holes.
1
Install the Handles
Page 5
X1
X4
X4
X1
X4
X2
X4
X2
X1
X1
X1
X1