Section 2. Cleaner Specifications; Section 3. Getting Started; Contents; Connect To A Power Source - Polaris ALPHA iQ+ Owner's Manual

Polaris Robotic Pool Cleaner | Owner's Manual
®

Section 2. Cleaner Specifications

Technical Specifications
The general specifications for the cleaner are as
follows:
Control Box Supply
Voltage
Supply Voltage
Installed Load
Cable Length
Cleaner Size (WxDxH)
Weight of Cleaner
Packed Weight
Filtration
Cycle Lengths
The cleaner is a double-insulated product.
A double-insulated electrical appliance is one
which has been designed in such a way that it
does not require a safety connection to ground.
The basic requirement for double-insulation is that
no single failure can result in dangerous voltage
becoming exposed so that it might cause an
electric shock and that this is achieved without
relying on an earthed (grounded) metal casing. This
is achieved by having two (2) layers of insulating
material surrounding live parts or by using
reinforced insulation. Therefore, devices having
double-insulated construction, such as this cleaner,
do not utilize a grounded (three-prong) cord/plug.
100-125 VAC, 60 Hz
30 V DC
150 W max
60 ft (18 m) or 70 ft (21 m)
depending on model
16.9 x 18.9 x 10.6 in.
(43 x 48 x 27 cm)
21 lbs. (9.5 kg)
42 lbs. (19 kg)
Single filter canister
Variable programming

Section 3. Getting Started

3.1

Contents

The packaging should contain the following items:
• Robotic cleaner and floating cable
• Control box
3.2

Connect to a Power Source

WARNING
Failure to comply with the following warnings can result in permanent
injury, electrocution or drowning.
PREVENT ELECTRICAL SHOCK
U.S.: Per NEC
requirements, keep the control box at least 5 ft.
®
(1.5 m) from the edge of the pool.
CANADA: Per CEC requirements, keep the control box at least 3 m
(10 ft) from the edge of the pool.
Only connect the control box to a receptacle protected by a ground
fault circuit interrupter (GFCI). Contact a certified electrician if you
cannot verify that the receptacle is protected by a GFCI.
Do not use an extension cord to connect the control box.
Do not allow anyone to swim while the cleaner is in the pool.
The control box is water-resistant, not waterproof. In order to prevent
electrocution, never submerge the control box or leave exposed to
inclement weather.
1. Unscrew the protective cap for the floating
cable from the side of the control box by
turning counter-clockwise.
Figure 1. Remove Protective Cap
ENGLISH
Page 5