Electrical Connection; Section 4. Operation; Submerging The Cleaner - Polaris 9300 Sport Owner's Manual

Page 8

3.4 Electrical Connection

WARNING
Failure to comply with the following warnings can
result in permanent injury, electrocution or drowning.
PREVENT ELECTRICAL SHOCK
• AMERICAS: Per NEC requirements, keep the
control unit at least five (5) ft. (1.5 m) from the edge
of the pool. CANADA: Per CEC requirements, keep
the control unit at least three (3) m (10 ft.) from the
edge of the pool.
• Only connect the control unit to a receptacle
protected by a ground fault circuit interrupter (GFCI).
Contact a certified electrician if you cannot verify
that the receptacle is protected by a GFCI.
• Do not use an extension cord to connect the control
unit.
• Do not allow anyone to swim while the cleaner is in
the pool.
For your safety and to obtain the best possible
performance from your cleaner, connect the cleaner's
fl oating cable to the control unit and thread connector
until it is snug. Do not overtighten. Refer to Figure 15.
• The control unit is equipped with an automatic shut
off feature to prevent overheating if operated in direct
sunlight for an extended period of time.
WARNING
The control unit is water-resistant, not waterproof. In
order to prevent electrocution, which could result in
serious injury or death, never submerge the control
unit.
Figure 15. Electrical Connection
Power Supply
1
Connector
2

Section 4. Operation

4.1 Submerging the Cleaner

1. Submerge the cleaner in the pool and remove any
air trapped inside by keeping the unit vertical.
Refer to Figure 16.
1
Figure 16. Submerge the Cleaner Vertically
2. Ensure the unit sinks to the bottom of the pool.
Refer to Figure 17.
2
Figure 17. Cleaner on the Bottom of the Pool
3. Spread out the fl oating cable over the pool,
ensuring there are no kinks or coils in the cable.
Refer to Figure 18.
Figure 18. Spread Floating Cable Over the Pool