Advertisement

R
I M P O R TA N T I N F O R M AT I O N
SERIAL NUMBER

Advertisement

Table of Contents
loading

Summary of Contents for Polaris 3900 Sport

  • Page 1 I M P O R TA N T I N F O R M AT I O N SERIAL NUMBER...
  • Page 2 Customer Service Department at 1-800-822-7933 (USA and Canada only) or (760) 599-9600. Be sure to insure the shipment against loss or damage in transit. This limited warranty is valid only in the United States of America, Mexico and Canada, and it does not apply to Polaris ®...
  • Page 3 ® replacement parts. Non-Polaris ® parts are not made to our specifications. They may have an adverse effect on the operation of your Polaris ® or may even damage it. For best results, the cleaner should be installed by a pool professional. For those with experience and confidence in handling plumbing and mechanical equipment, installation is outlined in this manual.
  • Page 4 Quick Installation Instructions Install the Universal Wall Fitting Installs in minutes on pools with a dedicated cleaner return line. 1. Turn on the filtration pump and flush out the plumbing line.Turn pump off. 2. Remove the Universal Wall Fitting (UWF) from the Quick Disconnect and screw it into the return opening with the blue restrictor disk in place.
  • Page 5 Velcro strips. 3. Turn on the pool filtration pump and allow it to prime before turning on the booster pump. Check for Proper RPM Before operating the Polaris ® , check for Single-wheel Side proper wheel revolutions per minute (RPM).
  • Page 6: Thrust Jet Adjustment

    Fine Tuning The Cleaner When operating correctly, the cleaner vacuums, sweeps and scrubs all surfaces randomly throughout the pool. Approximately every three minutes the cleaner goes into back-up mode. This action pulls the cleaner away from pool obstacles and increases its random pattern. Thrust Jet Adjustment The thrust jet powers the direction of the cleaner.
  • Page 7 When storing for the winter, drain all the water from the cleaner (freeze damage is not covered under the warranty). Use the Quick Disconnect to remove the UWF from the pool wall. If necessary, use the UWF Removal Tool (part #10-102-00) available from any authorized Polaris ® dealer.
  • Page 8: Exploded Parts Diagram

    Polaris No. Part #Description Qty No. Part #Description Qty No. Part #Description 39-310 3900 Sport SuperBag* 16 39-440 Front Axle Block Assy 32 9-100-9002 Pressure Relief Valve, Black 39-003 Top Housing Assembly 17 48-045 Screw, 10-32 x 7/8" SS 33 D29 Quick Disconnect, UWF Screw, 10-32 x 3/8"...
  • Page 9: Troubleshooting

    Wheel RPM to increase 3. Make sure the feed hose flow to cleaner. is floating. Action: Cleaner races around the pool 4. With the Polaris ® operating, and/or does not make contact hold the cleaner under water with the pool bottom.
  • Page 10 The cleaner does not clean the entire pool. Solution: 1. Verify that feed hose reaches within 6” of the farthest point of the pool. If not, order a new hose section from your Polaris ® dealer. 2. Adjust thrust jet to improve coverage.
  • Page 11 If count is less than 30 RPM: • If an adjustable valve is installed on the cleaner line, open it completely so water can flow freely to the Polaris ® • Check the filter screen in the in-line filter for debris that restricts water flow.
  • Page 12 © 2008 Zodiac Pool Systems, Inc. All rights reserved. TL-875 9/08...

This manual is also suitable for:

3900

Table of Contents