Table of Contents
Advertisement
Bluetooth
Bluetooth setup
Auto connection
When an active device moves within Bluetooth range of the telephone base,
or is turned on within range, the telephone base tries to connect to the device.
When the device moves out of range, it is disconnected. Your device might
make a connect or disconnect sound.
A connected device could also be disconnected by:
•
Turning off the Bluetooth device.
•
Turning off the Bluetooth feature of the device.
Disconnecting through the telephone base Device list. If you disconnect
•
through the Device list, the telephone base will not attempt to reconnect
until your device is moved out of range and then moves back in
range again.
Bluetooth connection from idle mode
When you have active devices that are not connected,
the idle handset. Press
there are two active devices, the handset will prompt you to choose one before
connection.
Device list and connection
Up to 4 devices can be paired to the telephone base. All paired devices are
shown on the device list. To use a paired device, it must be connected and in
an active slot (D1: or D2:) on the device list. Both active devices can be on a
call at a time.
Once you have paired a device with the telephone base, you do not need
to repeat the pairing procedure again unless you delete the device from the
device list.
NOTE: When connecting a Bluetooth device to the device list, all connected devices will be
temporarily disconnected until the procedure is complete. It may take up to 2 minutes to
reconnect.
CONNECT
to start connecting an active device. When
20
CONNECT
appears on
Hide quick links:
Advertisement
Table of Contents
