Table of Contents
Advertisement
Getting started
Battery installation and charging
Step 1
Plug the battery connector
securely into the socket
inside the handset battery
compartment. Insert the
supplied battery with the
label THIS SIDE UP facing
up as indicated.
CHARGE light
After you install your telephone or power returns following a power outage,
the handset will prompt you to set the date and time. For instructions,
see Set date/time on page 30. To skip setting the date and time,
press
/CANCEL.
OFF
IMPORTANT INFORMATION:
•
Use only the supplied rechargeable battery or replacement battery (model BT183342). To order,
visit our website at
1 (866) 288-4268
In Canada, dial
•
If you do not use the handset for a long time, disconnect and remove the battery to prevent
possible leakage.
Step 3
Charge the handset by placing it face forward in the
telephone base or charger. The CHARGE light on the
top of the handset is on during charging.
www.telephones.att.com
or call
.
8
Step 2
Align the cover flat
against the battery
compartment, then
slide it upwards until
it clicks into place.
1 (800) 222-3111
.
Hide quick links:
Advertisement
Table of Contents
