Table of Contents
Advertisement
Bluetooth
Bluetooth setup
6.
Set your headset to discoverable mode (refer to the user's
manual of your headset), then press NEXT. The screen
displays Searching for Bluetooth headsets...
•
All devices that are connected to the telephone base
are temporarily disconnected.
7.
When the screen displays the found devices, press
or
to highlight your headset if necessary, then press
DIR
SELECT.
•
Enter the PIN of your headset if required. The PIN for
most Bluetooth devices is 0000 (refer to the user's
manual of your headset). Press
The screen displays Adding Headset A when the base is
connecting to your headset.
When a device is successfully connected, the handset
displays Headset A is added and connected to base and the
corresponding status icon ( 2) displays on the handset. You
hear a confirmation tone. The CELL 2/HEADSET light on the
telephone base turns on.
If you have trouble pairing your headset, it may not be
compatible with your TL92273/TL92373/TL92473. Check
the Bluetooth compatibility list at
NOTES:
•
The pairing process may take up to one minute. If the pairing process fails, try again.
•
If you put the handset back in the telephone base or charger while pairing, the process
discontinues and the handset returns to idle mode.
•
If a device fails to connect, the handset displays Headset A is added, and then displays Please
use headset to connect to base.
•
When a connected headset is charging, it may disconnect from the telephone base and the
corresponding light on the telephone base (CELL 2/HEADSET) turns off. For some headset
models, you may need to turn on the headset and reconnect it to the telephone base again.
NEXT
to continue.
www.telephones.att.com/bluetooth
19
Searching for
Bluetooth
headsets...
CID
FOUND DEVICES
Headset A
Headset B
BACK
Adding
Headset A
1
Headset A
is added
and connected
to base.
SELECT
.
Hide quick links:
Advertisement
Table of Contents
