Cx-1 Disc Publisher Installation; Windows Component Prerequisites; Connecting To Apc - MicroBoards Technology CX-1 User Manual

CX-1 Disc Publisher Installation

The CX-1 Disc Publisher installation disk includes an Installer that will walk
you through the process step by step. Please use the Installer and follow the
The following installation sections are intended only as a reference for the installation process, not as
a guide to installing the CX-1 Disc Publisher. Performing the installation out of order could result in
an unsuccessful installation.
The CX-1 Disc Publisher Installation Quick Reference Guide will show you the order in which the
installation will occur.
Installation should always be done when logged in as a user with full Administrator rights.

Windows Component Prerequisites

During the installation process, your PC will be checked to determine if 2 required Microsoft Windows
components are present.
installation without installing these necessary Microsoft Windows components.
Connecting to a PC
DO NOT CONNECT YOUR CX-1 DISC PUBLISHER TO A COMPUTER BEFORE
RUNNING THE INSTALLER LOCATED ON THE INSTALLATION DISK!!
The connection between the PC and the Microboards CX-1 Disc Publisher is done with one USB
cable.
1. Confirm that the AC power cord to the back of the CX-1 Disc Publisher is connected and that
the switch in the back is ON.
2. Confirm that your PC is powered on.
3. Connect the square shaped end of the USB cable to the back of the CX-1
Disc Publisher.
4. Connect the flat, rectangular end of the USB cable into a USB 2.0 port in
your PC.
10
installation steps in order.
If not, these components will be installed. You cannot continue the