System Requirements; Assembly And Installation; Assembly Instructions; Gx-2 Disc Publisher Assembly - MicroBoards Technology GX-2 User Manual

System Requirements

The Microboards GX-2 Disc Publisher has the following minimum requirements and compatibilities:
Operating System
Mac OS 10.5 or above.
Processors
Intel Processor is required.
System Memory
Minimum 512 MB of system memory. 1GB is recommended for DVD recording operation.
Hard Drive
A separate internal 7200 RPM hard drive is recommended for storing your data. Using the same
hard drive as the operating system can cause the system to perform slowly.
USB Connection
USB 2.0 is required. USB 1.1 is not supported, as using USB 1.1 will result in significantly longer
recording times and the potential for recording failures.

Assembly and Installation

Assembly Instructions

GX-2 Disc Publisher Assembly

Remove the GX-2 Disc Publisher system from the shipping box and
confirm you received all of the items.
Place the GX-2 Disc Publisher on a stable, flat surface. You will need
room both in front and to the left of the system, as discs will be
accessed from both locations.
The input bin posts are pre-installed, with the wide post to the front.
The Reject Bin is pre-installed on the left side of the GX-2 Disc
Publisher. This bin, which slides out, should be emptied when you
know discs have been rejected.
Slide the 50-disc Output Bin into the channel between the feet at the
front of the GX-2 Disc Publisher, shown below.
6
Input Rods
Output Bin