Altec Lansing inMotion iMT630 User Manual page 9

How to Install the Full-Featured Remote Battery
The remote battery (included) is not installed at the
factory. To install the battery, follow the steps below:
1
Pull out the battery holder.
The battery holder is located on the lower end of
the back of the remote. Use a fingernail inserted
into one of the notches on either the side of
the remote to pull the battery holder out of the
remote.
2
Position the battery (included) so it sits in
the battery holder correctly.
Make sure the polarity (the + and – sides of the
battery) is correct.
3
Push the battery holder back into the remote, making sure the
battery stays in place.
You will hear and feel the battery holder click into place.
NOTE Please discard used batteries properly.
How to Dock Your iPhone or iPod
1
eject the dock connector, if
it's not already extended.
Depress and release the dock
connector. It's on the front of
the speaker system and has the
Altec Lansing logo on it. The dock
connector will extend into position.
2
Place your iPhone or iPod into position.
Align your iPhone or iPod's connection port with the dock connector
on the inMotion iMT630 speaker system. Slide your iPhone or iPod
onto the dock connector.
NOTE Your iPhone or iPod can be in a skin or thin cover, but not too thick
of a cover in order to dock properly.
How to Turn On Your Speaker System
1
Make sure you have power to the unit.
Ensure the AC adapter is connected to the system and plugged into
the wall. See the Getting Started section for more information. If the
battery is charged, the AC adapter can be disconnected.
2
Turn on the unit.
Press the button on either the speaker system or the remote.
How to Turn Off Your Speaker System
Turn off the unit.
Press the button on either the speaker system or the remote.
Alternately, you can close the support stand to turn off your speaker
system.
NOTE Whenever you are finished listening to your music, please remember
to turn off your speaker system and portable device to conserve energy.
7