Table of Contents
Advertisement
Function Description:
Report the latest updated status of all ports in this switch. When any one of the ports in the
switch changes its parameter displayed in the page, it will be automatically refreshed the
port current status about every 5 seconds.
Parameter Description:
Port:
Link:
Speed / Duplex Mode:
Flow Control:
Port Description:
Parameter description of Port 21 ~ Port 24:
40
Display the port number. The number is 1 – 24. Both port 21
~ 24 are optional modules.
Show that if the link on the port is active or not. If the link is
connected to a working-well device, the Link will show the
link "Up"; otherwise, it will show "Down". This is
determined by the hardware on both devices of the
connection.
No default value.
Display the speed and duplex of all port. There are three
speeds 10Mbps, 100Mbps and 1000Mbps supported for TP
media, and the duplex supported is half duplex and full
duplex. If the media is 1Gbps fiber, it is 1000Mbps
supported only. The status of speed/duplex mode is
determined by 1) the negotiation of both local port and link
partner in "Auto Speed" mode or 2) user setting in "Force"
mode. The local port has to be preset its capability.
Default: None, depends on the result of the negotiation.
Show each port's flow control status. There are two types of
flow control in Ethernet, Backpressure for half-duplex
operation and Pause flow control (IEEE802.3x) for
full-duplex operation. The switch supports both of them.
Default: None, depends on the result of the negotiation.
Network managers provide a description of device ports.
VigorSwitch G2240 User's Guide
Advertisement
Table of Contents
