Step 4. Positioning, Leveling, And Securing The Fireplace; Step 5 The Gas Control Systems - Heat & Glo Everest Owner's Manual

Step 4. Positioning, Leveling, and
Securing the Fireplace
The diagram below shows how to properly position, level,
and secure the fi replace.
NAILING TABS
(BOTH SIDES)
Figure 20. Proper Positioning, Leveling, and Securing
of a Fireplace
1. Place the fi replace into position.
2. Level the fi replace from side to side and from front to
back.
3. Shim the fi replace with non-combustible material, such
as sheet metal, as necessary.
4. Secure the fi replace to the framing by nailing or screw-
ing.
Step 5. The Gas Control Systems
Intermittent Pilot Ignition (IPI) System
The gas control system used with this model is Intermittent
Pilot Ignition (IPI). This system includes a 3V control valve,
electronic module, and intermittent pilot.
Heat & Glo • Everest • 750-900 Rev. o • 10/08
WARNING: THIS UNIT IS NOT FOR USE WITH
!
SOLID FUEL.
WARNING: CONTINUOUS 110-120 VAC SER-
!
VICE MUST BE WIRED TO THE FIREPLACE
JUNCTION BOX.
WARNING: DIRECT VENT PROPANE MODELS
!
WITH IPI CONTROL SYSTEMS CANNOT BE
USED IN CANADA.
Figure 21. Intermittent Pilot Ignition
22