Table of Contents
Advertisement
12
12
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
C. Accessories
Install approved accessories per instructions included
with accessories. See Service Parts List for appropriate
accessories. Refer to Section 16.
D. Ember Placement
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
•Place small pieces of ember material on burner top around
burner ports.
Do NOT press embers into burner ports.
Do NOT place embers in the center area shown in Figure
12.1.
• Use this material to give the appliance a realistic ash
bed.
• Save the remaining ember materials for use during
Heat & Glo • Soho-CE • 2111-900 Rev. D • 6/07
WARNING
Explosion Risk.
• Follow ember placement instructions in manual.
• Do NOT place embers directly over burner ports.
• Replace ember material annually.
Improperly placed embers interferes with proper burner
operation.
appliance servicing. The embers provided should be
enough for multiple applications.
Figure 12.1 Ember Placement
25
Advertisement
Table of Contents
