Telnet Settings; Vlans; Edit 802.1Q Vlans - IBM BladeCenter Installation And User Manual

Telnet Settings

Complete the following steps to display the Telnet Settings window:
1. Select Switch Setup from the Configuration menu (see "Configuration" on
2. Select Telnet Settings from the Switch Setup menu.
A window similar to the following opens:
The user-changeable parameters on this window are as follows:
Time Out <10 mins>
Sessions [1]

VLANs

This section includes Edit 802.1Q VLANs and 802.1Q Port Settings.

Edit 802.1Q VLANs

To create, modify, or remove an 802.1Q VLAN, select VLANs from the
Configuration menu (see "Configuration" on page 34) and Edit 802.1Q VLANs from
the VLANs menu. A window similar to the following opens:
40
IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation and User's Guide
page 34).
This sets the time that the Telnet interface can be idle before the switch
automatically logs-out the user. The options are: 2 mins, 5 mins, 10 mins,
15 mins, and Never.
This sets the maximum number of available Telnet sessions.