Connecting Network And Power Source - Polycom CX700 User Manual

User Guide Polycom CX700 IP Phone

Connecting Network and Power Source

1 - 4
VoIPon www.voipon.co.uk
2. Connect the headset (optional) to the headset jack on the back of the
phone (next to the handset jack).
A list of supported headsets is available in the Voice section of Polycom's Support
web site at http://www.polycom.com/support/voice/.
Note If headsets are deployed in high static environments where users frequently
disconnect and re-connect the headset to the phone, it is possible that the phone
can be damaged by electrostatic discharge (ESD).
You should take precautions to avoid excessive static buildup in your environment.
This can include humidity control and removal of synthetic materials near the phone
location. Antistatic spray applied to carpets in the workplace can reduce the level of
static buildup.
Use Power over Ethernet (PoE) for network and power source connections
unless otherwise directed by your system administrator.
The AC power adapter is a separate, optional accessory. Your system
Note
administrator will instruct you to use it if necessary.
To connect the network and AC power:
1. Plug the supplied network cable between the LAN jack on the phone and
an available network RJ-45 data port.
Using the supplied network cable, the phone can be powered from a PoE
(IEEE 802.3af) enabled network port.
If there is no PoE enabled network data part available, plug in the AC/DC
power adapter to the Polycom CX700 IP phone's power plug as shown
sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299