Electrical Service And Repair - Heat & Glo 6000GL-IPI-S Owner's Manual

PLUG-IN
3V TRANSFORMER
ON/OFF
WALL SWITCH
IGNITION
MODULE
(3V)
VALVE
GROUND
NEUTRAL
BLACK WIRE CAN BE
PLUGGED INTO ANY
OF #1 - #5 LOCATIONS
ON THE HOT SIDE
WHITE WIRE CAN BE
PLUGGED INTO ANY
OF#1 - #5 LOCATIONS
ON THE NEUTRAL SIDE
TRANSFORMER
3 VAC
PLUG-IN
Figure 12.2 Intellifi re Pilot Ignition (IPI) Wiring Diagram
D. Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
48
IGNITION MODULE 3 VAC
LOW VOLTAGE
SEE NOTE 1
REMOTE
CONTROL HOT
BLK
RED
Heat & Glo • 6000GL-IPI-R, 6000GL-IPI-S • 2102-900 Rev. O • 12/08
INTERMITTENT
PILOT IGNITOR
ORG
WHT
GROUND TO
FIREPLACE
CHASSIS*
ORG
VALVE
REMOTE
JUMPER WIRE
WARNING! Risk of Shock! Replace damaged wire with
type 105º C rated wire. Wire must have high temperature
insulation.
Note: Appliance will not operate
unless properly grounded.
THERMOSTAT
WIRE
ASSEMBLY