Pc Card Slot; Removing And Installing Memory Modules - Fujitsu Stylistic Manual

S t y l i s t i c S T 4 1 1 0 F u j i t s u Ta b l e t P C U s e r 's G u i d e - S e c t i o n O n e
If you need assistance configuring the Stylistic
ST4110 Fujitsu Tablet PC modem or LAN,
contact your local help desk or your reseller.

PC CARD SLOT

The Stylistic ST4110 Fujitsu Tablet PC Card
slot allows you to install a Type I or Type II
PCMCIA Card.
Installing a PC Card
To install a PC card, position the side with the
arrow facing up (i.e., when looking at the
tablet's display side, the arrow on the card
should be visible.) Slide the card into the PC
Card slot, and press it firmly to ensure proper
seating. (See Figure 2-3 for location)
If you need assistance installing a PC Card in
the Stylistic ST4110 Fujitsu Tablet PC, contact
your corporate help desk or your reseller.
Figure 2-3 Installing a PC Card
Removing a PC Card
To remove a PC Card, press the PC Card eject
button so that it pops out. Once the button has
popped out, press it firmly to eject the card.
(See Figure 2-4 for location)
Figure 2-4 Removing a PC Card
26
REMOVING AND INSTALLING
MEMORY MODULES
There is one DIMM slots in your Tablet PC and
256MB on the motherboard. 256MB and
512MB modules are available, so you can
install a combination of up to 768MB in the
system.
DIMM replacement should only be
performed at a static-free workstation.
Avoid touching connector pins, circuit
boards, or other circuit components on the
drive or Tablet PC. Electrostatic discharge
caused by doing so can damage sensitive
components.
Installing a Memory Module
To install a DIMM module in the Tablet PC:
1. Ensure that the Tablet PC is off. To do so,
carry out the Shut Down command in the
Start menu. (Do not attempt to remove or
install a DIMM module when the system is in
Suspend mode or running.)
2. Remove the two screws from the cover plate
on the back of the Tablet PC and remove the
cover plate as shown in Figure 2-5.
Figure 2-5 Accessing the Memory Slot