Calibrating The Pen; Installing A Pen Tether; Replacing The Pen Tip - Fujitsu Stylistic Manual

The Stylistic ST4110 pen is a sophisticated,
high-quality electronic instrument that can be
damaged if used improperly. Treat the pen as
you would any precision device. The following
list contains guidelines for proper pen handling:
Do not gesture with the pen, use it as a
pointer, or tap it on surfaces other than the
Tablet PC screen.
Do not try to turn the thumb grip on the pen;
it is designed for inserting and removing the
pen from the pen holder and for attaching a
pen tether.
Never store the pen with the tip bearing the
weight of the pen (e.g., sitting tip down in a
pencil cup). Storing the pen tip down could
distort the internal mechanism over a period
of time (especially in higher temperatures),
causing the tip to act as if it is always
depressed. To avoid damage, the pen should
be stored in the pen holder when not in use.
The screen reacts when the pen tip is approximately
1/8 inch (3-5mm) from the screen. The pen has
three switches: a tip switch and a barrel button
toggle switch with switches at both ends. When
activated, the tip switch corresponds to the left
mouse button, and the front toggle (closest to the
pen tip) barrel button switch, when used in
combination with the tip switch, corresponds to the
right mouse button. The rear toggle of the barrel
button switch acts as an electronic ink "eraser".
• Ensure that a screen protector is
installed on the Tablet PC screen before
you use the pen. The warranty does not
cover a screen that is scratched as a
result of not using a screen protector.
• Use only the pen provided with your
Tablet PC. Do not use substitutes that
were not designed for the Stylistic
ST4110 Fujitsu Tablet PC. Damage
caused by using an instrument other
than the provided pen is not covered by
the system warranty.
Here are some hints that may help you use the
pen more effectively:
U s i n g Yo u r S t y l i s t i c S T 4 1 1 0
• To activate the tip switch, tap or hold the
pen tip against the screen.
• To activate the barrel button switch, press
and hold the end of the button you wish to use
(front toggle is the right mouse button switch;
the rear toggle acts as an electronic "eraser".
• To move the cursor, hold the pen tip within
1/8 inch (3 - 5mm) from the screen and
move the pen.
• To start a program, double-tap the pen tip
(tap the pen tip twice rapidly) on the program
icon as you would double-click a mouse.
• To select an object, tap the pen tip on the
object once.
• To "double-click" an object, tap twice on
the object quickly.
• To move, or "drag", an object on the
screen, place the pen tip directly over the
object, then as you hold the pen tip against
the screen, move the pen.

CALIBRATING THE PEN

For information about calibrating your pen, refer to
the literature that came with the operating system.

INSTALLING A PEN TETHER

To prevent dropping or losing your pen, you
should attach it to your system using the pen
tether. (Pen tether is not provided)
To attach the pen tether to your Tablet PC,
perform the following steps:
1. Attach the end of the pen tether with the
smaller loop to your pen. Do do so, push the
end of the tether through the hole in the pen,
then thread the opposite end of the tether
through the loop. (See Figure 2-4.)
Pen tether
attachment
point
Smaller loop
Figure 2-4. Installing a Pen Tether
Larger loop
23