Powering Up The Table Pc; Shutting Down The System; Suspending System Operating - Fujitsu Stylistic Manual

S t y l i s t i c S T 4 1 1 0 F u j i t s u Ta b l e t P C U s e r 's G u i d e - S e c t i o n O n e
Current State
Icon Apperance
On State
Power icon
or
displayed
Idle State
continuously
Suspend-to-
Power icon
RAM
blinking
Off State, or,
Power icon not
displayed Hibernate
(Save-to-Disk )
* Information in Table 2-1 on page 20 is supplied to help you understand which system states your
system can enter from the current system state. Refer to the procedures on starting the system,
shutting down the system, suspending system operation, and resuming system operation given
later in this chapter.
Your system may be configured to use either Suspend-to-RAM mode or Hibernate mode.
POWERING UP THE TABLET PC
Follow the procedure below to start the Stylistic
ST4110 Fujitsu Tablet PC. Before you begin, confirm
that the system is in the Off state. To do so, observe
the Status display. If the Power icon is not visible in
the Status display, the system is in Off state or in
Hibernate (Save-to-Disk) mode and it is safe to
perform this procedure. If the Power icon is visible
(either blinking or on continuously), do not perform
this procedure. See "System States" earlier in this
chapter for details on modes represented by the
Power icon.
1. Ensure that the battery in your Tablet PC is
sufficiently charged, or connect an external power
source such as the AC adapter or auto adapter to
your Tablet PC.
2. Press the Power On/Suspend/Resume button to
start the system.
After performing initialization, the system starts the
operating system installed on the hard disk drive.
Once the operating system is running, you can use
the system.

SHUTTING DOWN THE SYSTEM

Follow these steps to shut down and turn off your
system:
20
To enter the Off state, shut down the system using the
Start menu on your system.
To enter Suspend-to-RAM or Hibernate (Save-to-Disk)
state, suspend system operation using either a hardware or
software suspend.
To enter the On state, resume system operation by
pressing the Suspend/Resume button.
To enter the Off state, resume system by pressing the
Suspend/Resume button, then shut down your system.
To enter the On state, start your system, or resume system
operation by pressing the Suspend/Resume button.
Table 2-1 Changing System States
1. If system operation has been suspended, resume
system operation. See "Resuming System Opera-
tion" later in this chapter for details.
2. Save your work and close all running programs.
3. Choose Shut Down from the Windows Start
menu.
4. Carry out the Shut Down command.
The system is now in the Off state.
SUSPENDING SYSTEM OPERATION
The Tablet PC allows you to suspend the system
operation without closing programs or exiting the
operating system. Use this feature to conserve
battery power when a system shutdown is not
practical or when the battery needs to be changed.
Purpose
If you have set your system to turn power
off from the Power Options utility in the
Control Panel, the following procedure will
not be possible, since pressing the button
shuts the system down rather than
suspending it. To change your power
options, go to Start -> Settings -> Control
Panel -> Power Options.