Resuming System Operation; Adjiusting The Display Brightness; Using The Pen - Fujitsu Stylistic Manual

S t y l i s t i c S T 4 1 1 0 F u j i t s u Ta b l e t P C U s e r 's G u i d e - S e c t i o n O n e
• The suspend action of the Suspend/Resume
button may be disabled to prevent accidental
interruption. If this is the case, pressing the
Suspend/Resume button will not suspend
system operation as described here. (In this
case, suspend mode can only be achieved
using the system software). Contact your
local help desk or reseller if your system
configuration is not suitable.
• If your system is equipped with a PC Card that
allows you to connect to a wired or wireless
network, you may be logged off the network
after a period of inactivity while system
operation is suspended. Contact your network
administrator or help desk for details on log-off
parameters for your network.

RESUMING SYSTEM OPERATION

To resume system operation from either
Suspend-to-RAM or Hibernate modes, press the
Suspend/Resume button.
• From Suspend-to-RAM mode
Status lights indicate that the system state is
changing. It may take up to a minute before the
system returns to the On state and system
operation resumes. Note that the display turns on
shortly before the pen becomes active due to the
power-up sequences observed by the system.
• From Hibernate (Save-to-Disk) mode
Active data is read from the hard disk drive,
and the system returns to the On state after a
short time.
Note that power to several system
components must be restored before
system operation resumes. Allow
sufficient time for system operation to
resume before attempting to use the
system. If your system uses Hibernate
mode, it will take longer to resume
operation as compared to using Suspend-
to-RAM mode. Time is needed to read
data from the hard disk drive.
• Use the system as you normally would once
system operation resumes.
All programs resume at the point where execution
stopped when system operation was suspended.
22
ADJUSTING THE DISPLAY BRIGHTNESS
There are two ways to adjust the brightness of
your display:
Depending upon whether you are
running your system on battery or AC
power, the default screen brightness
settings will be different. The screen
brightness default for running on battery
is lower than that on AC power in order
to optimize battery life.
• Click the Tablet icon in the system tray at the
bottom right of the screen. (When the cursor is
on top of the icon, a message stating "Change
tablet and pen settings" is displayed.) When
the Tablet and Pen Settings window appears,
select the Display tab, and move the Screen
Brightness slider to change the brightness.
• Click Start -> Settings -> Control Panel ->
Tablet and Pen Settings. Select the Display tab,
and move the Screen Brightness slider to
change the brightness.

USING THE PEN

You can use the Stylistic ST4110 Fujitsu pen to
generate and create electronic "ink", to select
items, and to navigate through programs on
the Tablet PC. Programs that support
handwriting recognition also allow you to write
characters directly on the screen with the pen.
You can also use the pen as a drawing tool.
Pen Tether Attachment Point
Tip switch
Barrel Switch
Figure 2-1 Stylistic ST4110 Pen