Fujitsu Stylistic Manual page 35

3. Insert the DIMM module in the socket at an
angle and push it down until it locks into place
as shown in Figure 2-6. Note that the DIMM
module is keyed to prevent it from being
inserted backwards.
Figure 2-6 Installing a DIMM Module
4. Reinstall the cover and screws that you
removed in step 2.
5. Confirm that the DIMM module is recognized
by the system. To do so, run BIOS Setup. The
size of the DIMM module should be displayed
in the Info menu in BIOS Setup.
The DIMM module is installed in the Tablet PC
and you can now use the system.
U s i n g Yo u r S t y l i s t i c S T 4 1 1 0
Removing a Memory Module
To remove a DIMM module:
1. Ensure that the Tablet PC is off. To do so, carry
out the Shut Down command in the Start
menu. (Do not attempt to remove or install a
DIMM module when the system is in Suspend
mode or running.)
2. Remove the screws from the cover plate on
the back of the Tablet PC and remove the cover
plate as shown in Figure 2-5.
3. Spread the fingers on the socket that lock the
DIMM module in place until the DIMM module
is loose.
4. Remove the DIMM module from the socket.
The DIMM module is now removed from the
Tablet PC. Refer to "Installing a Memory Module"
on page 26 to install a new DIMM module.
27