Amp Loop Ground Lift Switch; Amp Loop; Stomp Loop - DigiTech iPB-10 Owner's Manual

iPB-10 Rear Panel iPB-10 Rear Panel

Amp Loop Ground Lift Switch

This switch can be enabled to help prevent unwanted
hum or buzz caused by ground loops between the iPB-10
and an externally connected amplifier or preamp.
Status messages will be displayed if the AMP or STOMP footswitches are pressed and the Amp or Stomp Loop
NOTE:
modules are not used in the current preset Tone (unavailable), or if nothing is connected to these jacks (not connected).

Amp Loop

These 1/4" send and return jacks allow you to connect an
external preamp or amplifier and use the tone from these
components instead of the internal amplifiers of the iPB-10.

Stomp Loop

These 1/4" send and return jacks
allow you to insert an external
stompbox effect pedal (or chain
of effects) into the iPB-10 signal
path.
20