Refl ector Brackets Installation
1. Position FRONT Refl ector (7) so it
points straight forward (fi g 10).
2. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will
damage the Clamp.
Installing Derailleur Guard (on some models)
1. Remove Screws (11) from Frame Tabs (A).
2. Install Guard (12) using two Screws (11).
3. Make sure the Guard does not contact the Derailleur (B).
4. Tighten Screws (11) securely.
11
fig 12
1. Position REAR Refl ector (10) so it
2. Tighten Clamp Screw.
10
NOTE: Do not over-tighten. This will
fig 11
damage the Clamp.
A
B
12
7
points straight backward (fi g 11).
fig 10
19