Rear Derailleur Adjustments - Huffy Mountain Bikes Owner's Manual

Rear Derailleur Adjustments

The rear derailleur has two adjusting screws. The "low" adjusting screw, sometimes
marked "L", limits how far the rear derailleur and chain can move toward the wheel.
The "high" adjusting screw, sometimes marked "H", limits how far the rear derailleur
and chain can move away from the wheel.
Put the "high" adjusting screw in the correct position as follows:
• Shift the chain onto the smallest rear sprocket. Loosen Nut (C) of the cable
clamp.
• Turn the lever Barrel Adjuster (A) and rear Derailleur Adjustor (B) all the way IN
(fi g 21).
• Turn the "high" adjusting Screw (G) so the Jockey Roller (D) is in line with the
outside edge of the smallest rear Sprocket (E) (fi g 22).
• Remove the slack from the cable wire and tighten the Nut of the cable clamp.
30
B
F
A
fig 21
E
D
G
H
C
fig 22