Front And Rear Refl Ector Installation - Huffy 700c Owner's Manual

Testing Seat Clamp and Post Clamp Tightness - continued
• If the Seat Post (10) moves in the Seat Tube (B) (Screw Clamp):
• Loosen the clamp Screw (A).
• Put the seat in the correct position
and tighten the Screw tighter than
before.
• Do this test again, until the seat post
does not move in the seat tube.
Front and Rear Refl ector Installation
1. Position FRONT Refl ector (30) so it
points straight forward.
2. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will
damage the Clamp.
33
16
1. Position REAR Refl ector (33) so it
points straight backwards.
2. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will
damage the Clamp.
B
A
30
fig 12