Model Designations - Hatco GLO-RAY GR Installation & Operating Manual

IMPORTANT SAFETY INFORMATION
CAUTIONS
Standard and approved manufacturing oils
will smoke up to 30 minutes during initial
start-up. This is a temporary condition. To
assure safe operation, operate unit without
food product until smoke dissipates.
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
To prevent unit failure do not add a
decorative soffit to hide a pass-through
mounted Glo-Ray Strip Heater.
Strip Heaters with incandescent lights that
require a circuit breaker larger than 20 amps
must have a separate circuit breaker for the
incandescent lights that is 20 amps or less.
To assure safe and proper operation refer to
Installation Clearance Requirements listed in
this manual.
Installation of two or more single units with
less than 3" (76 mm) between housings may
result in premature failure of component
parts.
Unit is not moisture proof. Spacing of at least
16" (406 mm) is required for all units mounted
over a steam table.
MODEL DESIGNATION
GLO-RAY
Housing Type
A-Aluminum
N-Narrow Powder-Coated Steel
No Character-Stainless Steel Housing
High Wattage
Form No. GRM-0707
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your
unit, marring its appearance and making it
susceptible to dirt accumulation.
To prevent premature failure to components
the Remote Control Box (RMB) must be
installed outside the strip heater heat zone.
Heat damage to countertop material such as
Corian
stainless steel) is not covered under the
Hatco warranty. Contact the manufacturer of
the base material for temperature limits and
application information before installing the
unit.
GR A H L-24 D
Figure 1. Model Designation
2
NOTICE
®
and similar products (other than
Dual Strip Heater
Length in Inches
Incandescent Light