Table of Contents
Advertisement
REMOTE CONTROL ENCLOSURES
Hatco Remote Control Enclosures are available in
various sizes and configurations for use with the
Strip Heaters. All models are built in accordance
with U.L. standards to accommodate switches,
indicator lights and wiring. Consult the factory for
type and location of switches for enclosure.
NOTICE
To prevent premature failure to components the
Remote Control Box (RMB) must be installed
outside the strip heater heat zone.
NOTE: Proper use of RMB's require one RMB per
strip heater.
INCANDESCENT LIGHT
The Strip Heaters with aluminum housings may be
equipped from the factory with incandescent display
lights to illuminate the warming area.
Hatco shatter-resistant bulbs guard against injury
and food contamination in the event of breakage.
The display lighting meets NSF standards for food
holding and display areas.
NOTE: Display lights cannot be retrofitted to units.
INDICATOR LIGHT
An optional red indicator light is available for
mounting on either side of the unit. The indicator
light provides an instant visual check of the unit
operation.
C
D
Width
Models
(A)
RMB-3 Series
5-1/2"
(140 mm)
RMB-7 Series
9"
(229 mm)
RMB-14 Series
14"
(356 mm)
RMB-16 Series
16"
(406 mm)
RMB-20 Series
20"
(508 mm)
Figure 24. Dimensions -
Remote Control Box (RMB)
21
ACCESSORIES
A
Depth
Height
(B)
(C)
3"
2-1/2"
(76 mm)
(64 mm) (178 mm)
3"
2-1/2"
(76 mm)
(64 mm) (267 mm)
3"
2-1/2"
(76 mm)
(64 mm) (394 mm)
3"
2-1/2"
(76 mm)
(64 mm) (445 mm)
3"
2-1/2"
(76 mm)
(64 mm) (546 mm)
Form No. GRM-0707
B
Width
(D)
7"
10-1/2"
15-1/2"
17-1/2"
21-1/2"
Hide quick links:
Advertisement
Table of Contents
