Assembly; Portable Surface Mount - Hatco GLO-RAY GR Installation & Operating Manual

ASSEMBLY

Glo-Ray ® Strip Heaters are shipped with most
components pre-assembled.
available with a required 3" (76 mm) or 6" (152 mm)
spacer pre-assembled at the factory.
Optional breath protectors, mounting equipment and
remote control enclosures must be installed on
location.

PORTABLE SURFACE MOUNT

T-Leg Stand
NOTE: T-Leg not to be used with dual Glo-Ray units.
NOTE: T-Leg stands available in standard wattage -
10" (254 mm), high wattage - 13-1/2" (343 mm), 16"
(406 mm), and 18" (457 mm).
1. Position the unit upside-down on a flat surface.
2. Remove the two screws and mounting tabs from
each end of the unit.
3. Position the mounting bracket on the underside
of the unit and remove the two screws on the unit
that match up with the holes on the mounting
bracket.
4. Secure the mounting bracket to the unit with the
previously removed screws.
5. Align two mounting holes on side of T-Leg with
two holes on end of unit and attach leg with
screws supplied.
6. Align the mounting hole on the T-Leg bracket
with the hole on the mounting bracket and
secure with a screw. (See Figure 13.)
C-Leg Stand
NOTE: C-Legs are not to be used with dual Glo-Ray
models.
NOTE: Two types of C-Legs are available. CL-Low,
10" (254 mm) clearance, is for standard wattage
Glo-Ray models up to 6 ft. (1829 mm) in width only.
CL-High, 13-1/2" (343 mm) clearance, is for high
wattage Glo-Ray models up to 6 ft. (1829 mm) in
width only.
1. Position the unit upside-down on a flat surface.
2. Remove the two screws and mounting bracket
from each end of the unit.
Dual units are
13
T-Leg
Figure 13. T-Leg Stand End Mounting
Figure 14. C-Leg Stand
3. Attach C-Leg to each end of unit using original
screws. (See Figure 14.) Tighten screws
securely.
INSTALLATION
T-Leg Bracket
Form No. GRM-0707