Ceiling Mounting - Hatco GLO-RAY GR Installation & Operating Manual

Glo-ray gr, grh, gra, grah, gral, grahl, grn, grnh series infrared strip heaters
Table of Contents

Advertisement

CEILING MOUNTING

Chain Mounting
WARNING
To avoid any injury or damage to the unit when
using chains for installation, the chains must
have sufficient strength and be securely
fastened, or the unit could become loose or fall.
Do not place anything on top of warmers
supported by chains.
Chain supplied by Hatco is constructed of sufficient
strength to securely hold the weight of the unit only
when properly mounted.
1. Securely fasten the chain to the surface above
the desired area. Be sure chain is located so the
unit will be suspended at a safe and proper
distance from walls, counter and food.
2. Loosen but do not remove the screws securing
the mounting tabs on each end of the unit.
Extend the tabs, then tighten the screws
securely. (See Figure 20.)
3. Attach a short piece of connecting chain to each
pair of mounting tabs. (See Figure 20.)
4. Attach overhead chain to the connecting chain
between the two mounting tabs. Repeat for other
end of unit. (See Figure 20.)
NOTE: Additional chain will be needed for dual
Glo-Ray units.
Chain Mounting with "S" Hook
Units supplied from Hatco with power cord attached
come with the connecting chain and "S" hook
already attached to the mounting tabs.
1. Securely fasten the chain to the surface above
the desired area. Be sure chain is located so the
unit will be suspended at a safe and proper
distance from walls, counter and food.
2. Attach both "S" hooks to the overhead chains
and ensure the unit is level. (See Figure 20.)
BREATH PROTECTOR (Optional)
1. Remove protective paper from the acrylic
surfaces.
2. Position the acrylic breath protector into the
channel on the warmer with the mounting holes
aligned. (See Figure 21.)
3. Secure the breath protector using the weld
screws and acorn nuts provided. Tighten weld
screws until snug. Do not overtighten.
Mounting Tabs
"S" Hook
Figure 20. Mounting with Chains
Weld Screws
Acorn Nuts
Figure 21. Installing Breath Protectors
17
INSTALLATION
Overhead Chain
Connecting Chain
ON
ON
GLO -RAY
PARTS &
SERVICE
-0607
ASSISTANCE
800-558
Foodw armer
WWW.HATCO
CORP.COM
N - HO T
CAU TIO
WI U.S.A
.
O
AUK EE,
OFF
COR P. MILW
U.S.A.
HATC O
O
UKEE, WI
OFF
CORP. MILWA
HATCO
Breath Protector
Form No. GRM-0707

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Glo-ray grahGlo-ray grhGlo-ray graGlo-ray grnGlo-ray grnhGlo-ray grahl ... Show all

Table of Contents