to NETGEAR FVL328 or FWAG114 VPN Router
Follow these procedures to configure a VPN tunnel from a NETGEAR ProSafe VPN Client to an
FVL328. This case study follows the Virtual Private Network Consortium (VPNC)
interoperability profile guidelines. The configuration options for the FVS328 and FWAG114 are
the same.
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table H-1.
Summary
VPN Consortium Scenario:
Type of VPN
Security Scheme:
Date Tested:
Model/Firmware Tested:
Gateway
Client
IP Addressing:
Gateway
Client
NETGEAR VPN Client to NETGEAR FVL328 or FWAG114 VPN Router
Scenario 1
PC/Client-to-Gateway
IKE with Preshared Secret/Key (not Certificate-based)
December 2003
NETGEAR FVL328 firmware v 1.5 or FWAG114 firmware v 2.1
NETGEAR ProSafe VPN Client v10.1
Static IP address
Dynamic
202-10015-01
Appendix H
NETGEAR VPN Client
H-1