NETGEAR FVL328 Reference Manual page 77

The VPN Manual Policy fields are defined in the following table.
Table 6-1. VPN Manual Policy Configuration Fields
Field
General
Policy Name
Remote VPN Endpoint
Traffic Selector
Local IP
Remote IP
Virtual Private Networking
Model FVL328 ProSafe High-Speed VPN Firewall Reference Manual
Description
These settings identify this policy and determine its major characteristics.
The name of the VPN policy. Each policy should have a unique policy name.
This name is not supplied to the remote VPN Endpoint. It is used to help you
identify VPN policies.
The WAN Internet IP address or Fully Qualified Domain Name of the remote
VPN firewall or client to which you want to connect. The remote VPN endpoint
must have this FVL328's WAN Internet IP address entered as its "Remote
VPN Endpoint."
These settings determine if and when a VPN tunnel will be established. If
network traffic meets all criteria, then a VPN tunnel will be created.
The drop-down menu allows you to configure the source IP address of the
outbound network traffic for which this VPN policy will provide security.
Usually, this address will be from your network address space. The choices
are:
• ANY for all valid IP addresses in the Internet address space
Note: Choosing ANY sends all traffic through the tunnel, which will eliminate
activities such as Web access.
• Single IP Address
• Range of IP Addresses
• Subnet Address
The drop-down menu allows you to configure the destination IP address of the
outbound network traffic for which this VPN policy will provide security.
Usually, this address will be from the remote site's corporate network address
space. The choices are:
• ANY for all valid IP addresses in the Internet address space
Note: Choosing ANY sends all traffic to the WAN through the tunnel,
preventing for example, remote management or response to ping.
• Single IP Address
• Range of IP Addresses
• Subnet Address
M-10144-01
6-11