Dynamic Navigation - Blaupunkt TravelPilot DX-R4 Operating Instructions Manual

Dynamic navigation

During dynamic navigation, the TravelPilot analyses digital traffic information
messages and uses this information when planning the route. The traffic
messages are received from TMC (Traffic Message Channel) stations. These
are RDS stations which also broadcast their traffic messages in digital form
(for further information, read the section entitled "TMC" in the "Radio mode"
chapter).
Before you can use dynamic navigation, you must first select the DYN. option for
the ROUTE menu item. The ROUTE menu item can be found under the ROUTE
OPTION menu item in the navi menu. The route option settings are kept until
they are changed again.
If you want to make a currently active navigation session dynamic,
press the MEN button : during the navigation session.
1
The navigation session's navi menu appears.
2 Select ROUTE OPTION.
Press the right knob/pushbutton ;.
3
4 Highlight the ROUTE menu item.
Keep pressing the right knob/pushbutton ; until DYN. appears in the
5
display.
6 Highlight the CONTINUE menu item.
Press the right knob/pushbutton ;.
7
The unit switches back to navigation, and the settings are kept until they
are changed again.
Note: When in dynamic navigation mode, the TravelPilot automati-
cally sets a TMC station during navigation. If there is no TMC sta-
tion stored in the FMC memory yet, TMC seek tuning begins. TMC
seek tuning can take a long time because the entire frequency range
is scanned for TMC stations. Radio mode is not available during
this time.
INTRODUCTION NAVIGATION RADIO MODE CD MODE
NAVI. MENU
ROUTE OPTION
ROUTE LIST
POSITION MARK
TA
SYMBOLS
ROUTE OPTION
ROUTE
CONTINUE
CD CHANGER SETUP
OFF
2D
DYN.
35
INDEX