Supplied Accessories - Kenwood DNX7150DAB Quick Start Manual

• Insulate unconnected wires with vinyl tape or other
similar material. To prevent a short circuit, do not
remove the caps on the ends of the unconnected
wires or the terminals.
• Connect the speaker wires correctly to the terminals to
which they correspond. The unit may be damaged or
fail to work if you share the ¤ wires or ground them to
any metal part in the car.
• When only two speakers are being connected to
the system, connect the connectors either to both
the front output terminals or to both the rear output
terminals (do not mix front and rear). For example,
if you connect the ¢ connector of the left speaker
to a front output terminal, do not connect the ¤
connector to a rear output terminal.
• After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
• Mount the unit so that the mounting angle is 30° or
less.
• This unit has the cooling fan to decrease the internal
temperature. Do not mount the unit in a place where
the cooling fan of the unit is blocked. Blocking these
openings will inhibit the cooling of the internal
temperature and result in malfunction.
Cooling fan
• Do not press hard on the panel surface when installing
the unit to the vehicle. Otherwise scars, damage, or
failure may result.
• Reception may drop if there are metal objects near
the Bluetooth antenna.
DNX7150DAB DNX715WDAB
Bluetooth antenna unit
20
ñ English
Ñ Supplied accessories
First of all, make sure that all accessories are
supplied with the unit.
1
3 [1][2]
[3]
5
7
9 [1]
Ñ Unit
1) To prevent a short circuit, remove the key from
2) Make the proper input and output wire
3) Connect the wire on the wiring harness.
4) Take Connector B on the wiring harness and
DNX4
5) Take Connector A on the wiring harness and
6) Connect the wiring harness connector to the
7) Install the unit in your car
8) Reconnect the ¤ battery.
9) Press the <Reset> button. (P.4)
10) Perform the Initial Setup.
2
x1
4
x1
6
x1
8
x1
[1]
[2]
[3]
x1
the ignition and disconnect the ¤ terminal of
the battery.
connections for each unit.
connect it to the speaker connector in your
vehicle.
connect it to the external power connector on
your vehicle.
unit.
See First Step (P.6).
(2 m)
x1
[3]
x2
(3.5 m)
x1
(3 m)
x1
DNX7150DAB only
DNX715WDAB only
Except DNX715WDAB