APRILIA RS 50 TUONO Use And Maintenance Book page 64

Withdraw the exhaust terminal (6) from
◆
the flange (8).
NOTE
Upon reassembly, insert the exhaust
terminal (6) in the flange (8), making sure that
the tailpipe (9) is directed downwards.
Remove the gasket (10).
◆
NOTE
Upon reassembly, replace the
gasket (10) with a new one.
Remove any deposit from the flange (8)
◆
and the gasket seat (11).
NOTE
Prepare a flexible cleaning brush
(12) with suitable diameter.
use and maintenance RS 50 Tuono
64
CAUTION
Do not use any object or tool other than
the cleaning brush.
Do not insert any object, especially if
small, in the exhaust silencer or in the
exhaust terminal.
Do not insert the cleaning brush too
deeply.
Keep to the indicated depth.
Apply a reference mark (13) (like a piece
◆
of coloured adhesive tape) on the
cleaning brush, in order to indicate the
depth to be respected.
Depths to be indicated on the cleaning
brush:
A) = 320 mm; B) = 125 mm; C) = 250 mm
NOTE
After every cleaning operation,
remove the reference mark and remove
any deposit from the cleaning brush.
Insert the cleaning brush in the flange
◆
hole (14), without exceeding the depth
(A).
NOTE
Use the cleaning brush pushing it
forward and backward.
Clean the final pipe of the exhaust
◆
silencer (15) by means of the cleaning
brush.
NOTE
For the following operations,
position the exhaust terminal (6) vertically
and insert the cleaning brush from the
lower side.
Insert the cleaning brush in the inlet hole
◆
(16), without exceeding the depth (B).
Clean the inlet pipe (17) by means of the
◆
cleaning brush.
Rotate the exhaust terminal by 180°.
◆
Insert the cleaning brush in the outlet hole
◆
(18), without exceeding the depth (C).
Clean the outlet pipe (19) by means of
◆
the cleaning brush.