REMOVING THE RIDER SADDLE
Carefully read p. 39 (MAINTENANCE).
Position the vehicle on the stand.
◆
Insert the key (1) in the lock (2).
◆
Rotate the key (1) clockwise.
◆
Raise and remove the saddle (3).
◆
Remove the flap (4).
◆
Upon reassembly:
Position the flap (4) correctly.
◆
Insert the rear tangs (5) of the saddle in
◆
the appropriate seats (see figure).
Lower the saddle and insert the two pins
◆
(6) in the relevant seats.
Turn the key (1) anticlockwise, locking
◆
the saddle.
WARNING
Before leaving, make sure that the
saddle (3) is properly positioned and
locked.
use and maintenance RS 50 Tuono
52
7
9
8
REMOVING THE SUMP GUARD
Carefully read p. 39 (MAINTENANCE).
CAUTION
Before carrying out the following
operations, let the engine and the
exhaust silencer cool down.
Position the vehicle on the stand.
◆
Unscrew and remove the four screws
◆★
(7).
Remove the sump guard (8).
◆
CAUTION
H a n d l e t h e p l a s t i c a n d p a i n t e d
c o m p o n e n t s w i t h c a r e a n d a v o i d
scraping or damaging them.
10
11
REMOVING THE SIDE FAIRINGS
Carefully read p. 39 (MAINTENANCE).
CAUTION
Before carrying out the following
operations, let the engine and the
exhaust silencer cool down.
Position the vehicle on the stand.
◆
Unscrew and remove the screw (9).
◆★
Remove the front air scoop cover (10).
◆★
Unscrew and remove the two screws
◆★
(11).
Unscrew and remove the screw (12).
◆★
Remove the right side panel (13).
◆★
CAUTION
H a n d l e t h e p l a s t i c a n d p a i n t e d
c o m p o n e n t s w i t h c a r e a n d a v o i d
scraping or damaging them.
12
13