Memory Display Function - Sekonic DIGI MASTER L-718 Operating Instructions Manual

Memory Display Function

DIGI MASTER is equipped with a memory function for measured 2 F-stop
values. This function is usable for both wireless (cordless) and wired
measurements for a single flash light as well as ambient light measurement
in T-priority mode, but not for cumulative flash measurement.
(1) After measurement, press the
memory key. The measured F-stop
value is memorized and displayed in
bar dot symbol (Fig. 27).
(2) The number of measurement to
be memorized is limited up to 2
(Fig. 28).
(3) If you press the memory key after 2
dots have been displayed, the third
dot starts flashing (Fig. 29). After 2
or 3 sec., flashing stops and the
third dot is also remaining on the
display. This third dot is not a
display of memorized value, and will
be replaced by the following
measurement.
20
(4) Memory mode is released by
pressing the memory-off key
(Fig. 30).
21