Liquid Crystal Display - Sekonic DIGI MASTER L-718 Operating Instructions Manual

Liquid Crystal Display

(1) b.c. mark (battery check) is
displayed when the meter is
switched on.
(2) Digital value of the measured
F-stop or EV is shown (f/1~
f/90 or EV(- 1) ~ EV25), when
the meter is used in T-priority
mode.
(3) F-stop value is set in F-priority
mode for ambient light
measurement.
(4) E.u. (underexposure) or E.o.
(overexposure) mark is
displayed when the measuring
range is exceeded.
By pressing F/EV key, the indicated
symbol is converted from F to EV,
and vice versa. When the meter is
used in the flash mode, only F mark
is displayed.
When the meter is used in T-priority
mode,
(1) F-stop number is also displayed
in bar-dot symbols at 1/2 F-stop
increments.
(2) The measured F-stop values
are indicated in bar dot symbol
by pressing the memory key
after each measurement. The
number of memorized values is
limited up to 2.
4
Any of the following symbols is
displayed depending on the mode
selection.
for wireless (cordless)
measurement for flash light
for wired measurement for
flash light
for cine mode
In case of ambient light
measurement (excepting cine
mode), no symbol mark is
indicated.
This display comes into operation
when the multi-measurement key is
pressed in both modes of wireless
and wired measurement for flash
light. The number of cumulative
flashes is limited up to 9. If it
exceeds 9, the E mark (error) is
indicated.
(1) Battery capacity is shown when
the meter is switched on.
(2) Bar symbols indicate the
fractions of F-stop or EV value.
Display for film speed moves
through a range of ISO 3 ~ ISO
8000 by pressing either UP or
DOWN key while holding the ISO
key depressed.
(1) Digital value of the measured
shutter speed is shown in this
display (30min. ~ 1/8000sec.),
when the meter is used in
F-priority mode.
(2) Shutter speed is set in T-priority
mode;
for flash light:
1sec. ~ 1/500sec.
for ambient light:
30min. ~ 1/8000sec.
for cine scale:
6fps. ~ 128fps.
5