Building-In; The Furniture Door; Mounting The Furniture Door - Zanussi DTI 4725 Instruction Booklet

Building-in

The furniture door

The door on this appliance is designed for the
overlay or a panel having the following dimensions:
Width 446 cm
Height 644 - 714 mm max
Thickness 20 mm max
Weight 1.5 - 6 kg max
The panel height should be no more than
indicated, otherwise complete opening of the
door will no longer be possible as the panel
hits against the dishwasher plinth.
Mounting the furniture door onto the
door
The height of the panel depends on the height of
adjacent kitchen units (see kitchen plinth
adjustment).
The panel must be fitted with a handle, as the
dishwasher handle will be hidden by the panel. Drill
the panel with a Ø 2 x 12 bit according to the
dimensions indicated in the figure.
Fix cross bar onto the panel using 3.5 x 16 screws
provide. Reduce the length of fixing screw
according to the thickness of panel.
If for aesthetic matching the panel is provided with
a false draw (fitted or carved on the panel itself),
the two brackets provided should also be used.
Fix brackets according to the measurements
shown in the figure, by using four 3.5 x 16 screws.
Reduce the length of fixing screws according to
thickness of panel.
Mount the decor panel by inserting the two pivots
of the cross-bar into the slotted holes of the door.
Lift the decor panel until perfect alignment with the
fascia panel is obtained: if the two brackets have
also been used, they will automatically engage, in
the special holes provided on the dishwasher door.
Once the correct position has been found, open the
door and fasten the decor panel on the lower
section by means of the two 4 x 40 screws
provided, using the holes through the inner door.
446 max
360
*
II27
446 max
=
391,5
II26
II12
II10
49
*
=
PFI02GB