Service And Spare Parts - Zanussi DTI 4725 Instruction Booklet

Symptom
The dishes are not clean
(poor wash)
Visible lime deposits or white film on
the dishes
The dishes are not quite dry
If after all these checks, the problem persists,
contact your local Service Force Centre, quoting
the model and serial number. This information can
be found on the rating plate located on the right
hand side of the dishwasher door (see picture).

Service and spare parts

This product should be serviced by an
authorised Service engineer, and only
genuine spare parts should be used.
Under no circumstances should you
attempt to repair the machine yourself.
Repairs carried out by inexperienced
persons may cause injury or serious
malfunctioning. Contact your local
Service Force Centre.
Always insist on genuine spare parts.
Solution
The baskets are too full.
The dishes have not been arranged properly.
The spray arms do not rotate.
The spray arms are clogged.
The filters are clogged.
The filters are not in position.
Not enough detergent has been used or it is unsuitable.
The detergent is old or has gone hard.
The salt container cap is not properly closed.
The washing programme selected is too gentle.
The rinse aid has run out or too little is being used.
Check that there is salt and that the salt cap is tight.
The dishes have been too long inside the machine.
Mod. ........
RA01
44
Prod.No. ........ Ser. No. .........
PSN04GB