The Control Panel - Zanussi DTI 4725 Instruction Booklet

The control panel

1
In this fully integrated appliance the controls are
located on the top of the door. When selecting a
programme, the door needs to be partially opened.
Audible signals have been introduced to help
indicate which operations the dishwasher is
performing.
Short «instruction accepted» signal
When any of the buttons are pressed: a short
audible signal informs you that the machine has
accepted the instruction given.
Long «programme run» signal
A continuous audible signal lasting about one
second, heard only when you close the dishwasher
door, informs you that the washing programme is
starting.
Intermittent «end of programme» signal
An intermittent audible signal, lasting in total five
seconds, informs you that the wash programme
has ended. If you wish to deactivate these audible
signals, press both the «
programme buttons together for about 3 seconds,
until the intermittent audible signal can no longer
be heard.
70
SO66
To reactivate the audible signals, press both
buttons together again for about 3 seconds, until
an intermittent audible signal is heard.
2 3
65°» and « 55°»
65 55
55
4
1. On/Off pushbutton
Depress this button to switch the dishwasher
on. The On/Off indicator light illuminates
indicating that the washing programme can be
selected and started. Depress again this button
to switch the appliance off.
2. Salt refill indicator light
This light illuminates when the salt container
needs refilling. This light will remain on in a soft
water area where salt is not required.
3. On/Off indicator light
This illuminates when the On/Off button is
depressed, indicating that the machine is on.
4. Programme selector buttons
Depress the button corresponding to the
desired washing programme (see "Washing
programme" chart).
5. End of cycle indicator light
This light flashes when the programme has
finished. To switch it off depress the On/Off
button.
31
5
PCP02GB